SOFTWARE FIAT BSI FOR I/O TERMINAL
This software support FIAT BSI (Built in systems interface)
The BSI unit is the built-in systems interface which is at the heart of multi plex wired cars. Controls most things from the immobiliser to the wipers it is VIN encrypted (it will only work on your car) and the worst point it is expensive and an absolute nightmare to change. This being because you have to re configure the whole car.
This software via I/O TERMINAL unit allows you to READ/WRITE the EEPROM memories and retrieve the PIN CODE stored in BSI controller.
All operations are done via the OBDII connector or via the BSI connector on the bench.
Current BSI units supported:
- Read / Write the EEPROM memories
- Read / Write FLASH
- Reading the PIN code
R/W - Read/Write
|MAGNETI MARELLI 3K91D MC68HC912DG128||
|MAGNETI MARELLI 1K79X MC68HC9S12DG256||
|MAGNETI MARELLI NEC 70F3237||
|MAGNETI MARELLI NEC 70F3378||
|MAGNETI MARELLI NEC 70F3633||
Vehicles with Freescale 3K91D,1k79X MCU's:
- ALFA ROMEO: 147, GT
- FIAT: Stilo (1999 - 2007), Palio (1999 - up), Idea
- LANCIA: Thesis, Ypsilon
- MASERATI: Quattroporte, Granturismo
Vehicles with Freescale 70F3237,70F3378 MCU's:
- FIAT: Bravo (2007 - up), Ducato (2006 - up), Stilo (2007 - up), Punto (2007 - up)
- LANCIA: Ypsilon (2007 - up)
Vehicles with Freescale 9S12DG128 MCU's:
- FIAT: Panda (2003 - up)
Please note, this hardware differs from the regular I/O Terminal tool interface.
For new HW7.0 interfaces, please use the following modification: