DEN-ON Desoldering Gun - SC7000Z

£386.00
Product Code: SC7000Z_DESOL
Availability: In Stock


DEN-ON SC7000Z - Desoldering Gun

High-Performance Desoldering Tool




Best desoldering tool recognized all over the world !


Designed For Lead Free

Suction capacity and hot blow system are further powered up. Removal of chip, SMD components,SMT solder residue clean up is done with more ease and more efficiency.

SC-7000Z is of the pump built in structure with a temperature control circuit.




  • icon esd
  • icon pb
  • icon oryg




The SC-7000 is a reliable and solid tool for every electronic workshop from Denon Instruments (Reputable Japan Company) It's for desoldering with both a suction and hot air blowing function for SMD re-work. To desolder an IC simply set the required temperature on the "gun", move the tip to the required area, and press the trigger. The high power diaphragm pump then sucks the melted solder away, storing it in a small tube for clean and easy disposal. It has been designed for comfort and the pump vibration has been minimised to enable accurate shake-free positioning of the tip. A high quality tool that will considerably decrease the re-work time for boards and components.


Features

  • Low noise and low vibration.
  • Protection against ESD is secured.
  • Quite compact, light-weight unit portable and ready to use at any location.
  • The removal of SMD components can be easily done by a flick of the selector lever and by replacing the tip with the hot blow nozzle.
  • Direct connection between the diaphragm pump and the tip can provide high vacuum efficiency which can accommodate for the 8-12 layered PCB.
  • The combination of a 100W ceramic heater with sensor feedback temperature control circuit and high vacuum capacity can provide best work efficiency with no failure.


Applications


sc70001

Removing the solder

Removing the solder of DIP by the suction tip



sc70002

Melting the solder of QFP/SOP

Melting the solder of QFP/SOP by the hot blow for removal


sc70003

Melting the solder of PLCC

Melting the solder of PLCC by the hot blow for removal


sc70004

Melting the solder of SND

Melting the solder of other SNDsby the hot blow for removal




Time Required to Reach the Maximum Vacuum






Specifications


NameValue
VoltageAC100V, 120V, 230V, 50/60HZ
Power Consumption120W
PumpDiaphragm type
Motor output12W
Vacuum attained-86kpa
Time required to reach maximum vacuum0.1 seconds
Air flow rate (OPEN)15 liter/minute (Open)
Heater100W (Ceramic)
Control SystemFeed back zero cross over type
Temperature Range350 - 500°C
Insulation resistanceMore than 100MΩ
Max.Temperature of hot blow400°C
Plug Type44C CEE
Mains lead length5ft (152,4cm)
Weight420g
 




Comes with:

  • Oryginal box
  • Spare hot-blow filter pipe
  • Cleaning Pin Set
  • Manual


Download




Manufakturer website: www.denondic.co.jp





Write a review

Note: HTML is not translated!
    Bad           Good