DEN-ON Desoldering Gun - SC7000Z
DEN-ON SC7000Z - Desoldering Gun
High-Performance Desoldering Tool
Best desoldering tool recognized all over the world !
Designed For Lead Free
Suction capacity and hot blow system are further powered up. Removal of chip, SMD components,SMT solder residue clean up is done with more ease and more efficiency.
SC-7000Z is of the pump built in structure with a temperature control circuit.
The SC-7000 is a reliable and solid tool for every electronic workshop from Denon Instruments (Reputable Japan Company) It's for desoldering with both a suction and hot air blowing function for SMD re-work. To desolder an IC simply set the required temperature on the "gun", move the tip to the required area, and press the trigger. The high power diaphragm pump then sucks the melted solder away, storing it in a small tube for clean and easy disposal. It has been designed for comfort and the pump vibration has been minimised to enable accurate shake-free positioning of the tip. A high quality tool that will considerably decrease the re-work time for boards and components.
- Low noise and low vibration.
- Protection against ESD is secured.
- Quite compact, light-weight unit portable and ready to use at any location.
- The removal of SMD components can be easily done by a flick of the selector lever and by replacing the tip with the hot blow nozzle.
- Direct connection between the diaphragm pump and the tip can provide high vacuum efficiency which can accommodate for the 8-12 layered PCB.
- The combination of a 100W ceramic heater with sensor feedback temperature control circuit and high vacuum capacity can provide best work efficiency with no failure.
Time Required to Reach the Maximum Vacuum
|Voltage||AC100V, 120V, 230V, 50/60HZ|
|Time required to reach maximum vacuum||0.1 seconds|
|Air flow rate (OPEN)||15 liter/minute (Open)|
|Control System||Feed back zero cross over type|
|Temperature Range||350 - 500°C|
|Insulation resistance||More than 100MΩ|
|Max.Temperature of hot blow||400°C|
|Plug Type||44C CEE|
|Mains lead length||5ft (152,4cm)|
- Oryginal box
- Spare hot-blow filter pipe
- Cleaning Pin Set
Manufakturer website: www.denondic.co.jp